Side X Side World Forums banner

1 - 18 of 18 Posts
G

·
Guest
Joined
·
0 Posts
Discussion Starter #1
Bikeman Performance now has bored throttle bodies in stock for the 700 motor. These are taper bored from 48mm to 44mm resulting in 3 to 4 horsepower gain. Resulting in awesome throttle response and more midrange punch. Send your throttle body in on exchange. The price is 200.00. The stock bore on these throttle bodies is 40mm. This setup works really well with pipe and cam. Thanks Dale!
 
G

·
Guest
Joined
·
0 Posts
Discussion Starter #2


This will definately go on my "to do" list for the ultimate Ranger!!
 
G

·
Guest
Joined
·
0 Posts
Discussion Starter #3


I can also vouch for these, as well. When we added it to mine, we had to add 10 to the boondockers fuel controller just at idle because of the increased airflow. That equivalent to 3 jet sizes, just to give you and idea. I was literally blown away, to say the least.

Chris
 
G

·
Guest
Joined
·
0 Posts
Discussion Starter #4


Here's a pic of the difference between stock and modified:



Chris
 
G

·
Guest
Joined
·
0 Posts
Discussion Starter #5


This is also done to mine and is very good mod......Curt
 
G

·
Guest
Joined
·
0 Posts
Discussion Starter #6


Great picture Chris, more air more power. The picture says it all. Thanks Dale!
 
G

·
Guest
Joined
·
0 Posts
Discussion Starter #8


yes, dale told me they make a new butterfly after boring.
 
G

·
Guest
Joined
·
0 Posts
Discussion Starter #9


It's pretty slick Chuck! I had to raise my fuel settings on the boondocker 10 ticks from 3 to 13 just at idle.

Chris
 
G

·
Guest
Joined
·
0 Posts
Discussion Starter #11


Can you put this on a stock 700xp without having to make any other changes?
 
G

·
Guest
Joined
·
0 Posts
Discussion Starter #12


Yep, but you'll most likely need a fuel controller to add more fuel...Dale would know best, but I'd say it's required based on me needing to add 10 ticks on my boondockers.

Chris
 
G

·
Guest
Joined
·
0 Posts
Discussion Starter #15


You will need a fuel controller with a bored throttle body. I dont know if the doebeck will work in all the testing we did they were never able to add enough fuel. Yes we machine a new butterfly for the throttle body. Thanks Dale!
 
G

·
Guest
Joined
·
0 Posts
Discussion Starter #16


We also have bored throttle bodies for the 500 motor also. Thanks Dale!
 
G

·
Guest
Joined
·
0 Posts
Discussion Starter #17


What is available in a Fuel Controller,and where do you get one? I assume we're talking about a Fuel Injection Controller? "Electronic Control Unit" ?
 
G

·
Guest
Joined
·
0 Posts
Discussion Starter #18


I've used the Dobeck TFI, the Dynojet Power Commander, and now the Boondockers fuel controller. It's by far the easiest of all three of them to use, and nearly as adjustable as hooking up the laptop to the Dynoject.

Chris
 
1 - 18 of 18 Posts
Top